Why Choose Deli Shower Door?

- Jul 15, 2020-

ØTempered glass

Deli Company chose the best tempering plant in Guangdong (Jin Yaohua). The tempering equipment of this tempering plant uses all imported tempering equipment, which is effective to ensure that the tempering temperature (about 695°) and tempering time (12 minutes) of a glass Within this tempering temperature range, the national standard (50MM*50MM≧40 grains) of Deli Company has reached 60-80 grains, far exceeding the national standard. Higher than this temperature will lead to insufficient hardness and brittleness of the glass, lower than this temperature Will make the glass fragments uneven, leaving a safety hazard

image

ØHardware

 The stainless steel of Deli shower room is all 304 stainless steel. The main characteristics of this material are good hardness, high bearing capacity, non-oxidation, good corrosion resistance, beautiful and high-grade, easy to maintain, and long service life. After 48 hours of copper accelerated acetic acid salt spray test (PH value is between 3.2-3.5), it is equivalent to the bathroom environment for 20 years. Many shower room manufacturers choose 2 series stainless steel in pursuit of maximum profit and affordable price. Corrosion ability is poor, easy to oxidize, and the metal surface is constantly rusted, and its service life is greatly reduced. There are also many manufacturers in the market that use copper alloys. This material is mainly used for hinges, wall clips, and fences in shower rooms. It has good electrical conductivity, thermal conductivity, plasticity and corrosion resistance. However, due to the material characteristics, the hardness is low, and it is easy to rust when exposed to the air for a long time.

image

ØPulley

Deli shower room pays attention to the perfect matching of pulley and track from beginning to end. Deli shower room adopts imported stainless steel fully enclosed bearing structure at any cost, and high-temperature boiled nylon is added. The lubricating oil inside is completely sealed, so that the bearings inside are always kept in the best state of lubrication; Ø After 30,000 continuous and destructive push-pull tests, there is no damage or abnormality, and the normal service life is up to 10 years.

image